The
XBee
- Simple Board has been designed to allow an easy and reliable connection
between the Xbee's modules and your application. XBee and XBeePRO modules
are fully supported, even the new XBee Series 2 is supported (but not tested
yet). The rock solid construction and the high power voltage regulator
ensure the maximum reliability and full performances of the XBee module.
Two useful LEDs allow constant monitoring of the board activity and fast
troubleshooting.
You
can connect the Board in several methods. You can use two 12 pin male headers
to use the Board with a standard 24pin 2.54mm DIL form factor or you can
use only the pins you need for your application. You can also solder the
wires directly to the pins needed. A useful connector is provided on the
back side of the Board, here you can find the most important XBee connections.
A 90° strip header can be used here or any 2.54mm pitch connector,
depending on your application needs. The Board can be powered from a regulated
3.3V source, on any 3.3V pins, or from an unregulated power source up to
18V through the VIN pin. When the internal regulator is used, you can power
external devices from any 3.3V pins. The source power depends on the XBee
module installed.
Technical
Specifications:
XBee
Modules: XBee and XBeePRO are fully supported. XBee Series 2 are also supported
(but not tested yet)
3.3V
OUT - Output Power: depends on the Xbee module used. About 300mA available
with XBee, and 140mA with XBeePRO modules.
Dimensions:
37.5 x 27.5mm - max height 7 mm without XBee
Features:
RSSI
and ASSOCIATE LEDs to monitor Xbee activity
3.3V
OUT to power external devices (MCU’s, boards, etc)
DIL
24 form factor connector to use the Board on Bread Boards or other 2.54mm
pitch standard boards
9
pin 2.54mm pitch rear connector for easy and fast connection
Compact
Size just few millimeters bigger than an XBee Pro module
Software
Download:
Datasheet
(1.3MB)
Support:
If
you need additional support on the above product, and you can't find the
information you need in the documentation, then please contact support
at the address below:
This
product is from: Droids SAS
http://www.droids.it/
luigi
AT robot-italy.com
Mr.
Luigi Carnevale
Back
To Top
