This
is a very compact board for USB to TTL Serial conversion. Based on the
popular and powerful FTDI FT232 chip, you can find drivers for all of the
most common Operative Systems. The module works on 5.0V and 3.3V systems,
pin 7, 8 and 9 are used for voltage setting. All the most used signal pins
are available, a useful TX Enable pin is available for RS485 or similar
networks. Two useful LEDs allow constant monitoring of the TX and RX signals,
useful for fast troubleshooting. You can connect the Board in several methods,
some useful headers are included in the kit. You can also solder the wires
directly to the needed pins. Soldering two 9 pin headers (included) the
module can be used as a 2x9 DIL chip on standard breadboards and perfboards.
Simply
connect the device to a computer, install the proper drivers and a virtual
serial port will be available on your system.
Tecnical
Specifications:
-
USB 1.1/2.0 compatible
-
Dimensions: 18 x 25 mm - maximum height 8 mm
Features:
-
* TX e RX LED's
-
* 3.3V or 5.0V selectable serial levels
-
* Standard 2.54mm pitch
Software
Download:
PDF
Datasheet (105KB)
PDF
Datasheet FT232R (800KB)
LINK
FTDI Website (FT232R)
Support:
If
you need additional support on the above product, and you can't find the
information you need in the documentation, then please contact support
at the address below:
This
product is from: Droids SAS
http://www.droids.it/
luigi
AT robot-italy.com
Mr.
Luigi Carnevale
Back
To Top
