INFO:
AVR-ISP500-TINY
is fast and reliable USB AVR programmer. It have two modes of work: STK500
compatible USB programmer and USB Mass storage. In STK500 mode it working
directly with AVR Studio. It is recognized as STK500 programmer and programs
all AVRs. As it used USB CDC no need for drivers and works under Windows,
Linux and MacOS. If you do not want to use AVRStudio you can use AVR-ISP500
with AVR Dude. In Mass Storage mode it created new drive on your computer
and when you drag and drop the HEX file to this drive it program it in
the target AVR attached to the ICSP connector. This is totally platform
independant and works on any computer without need for any software.
AVR-ISP500-TINY
have internal flash of 2MB and can log AVRStudio communication and then
reply it with single button push. This means once you load the code in
the internal flash you can program quickly many targets with single button
press
FEATURES
-
connects
to PC via USB 2.0 Full speed
-
STK500
compatible mode
-
Mass Storage
mode
-
Internal
flash of 2 MB for stand alone programming with single button press
-
no need
for external power supply as it takes the power supply from USB
-
uses Atmel's
2x5 pin ICSP and 2x3 connector layout
-
dimensions
45x30 mm (1.7x1.2") + 20 cm (8") cable
DOCUMENTS:
HARDWARE:
SOFTWARE:
ADDITIONAL
INFORMATION
To
get BASCOM AVR Running with the usb programmer:
1.
Download AVRStudio from the ATmel website
(http://www.atmel.com/dyn/products/tools_card.asp?tool_id=2725)
2.
Install AVR Studio , make sure that the box for STK500 is selected
3.
In BASCOM-AVR go to Options-Programmer
4.
Select Programmer STK500
5.
For the STK500.EXE option browse to the folder where AVRStudio was installed
(ie:
C:\Program Files\Atmel\AVR Tools\STK500\Stk500.exe)
6.
Restart BASCOM AVR
My
machine selected COM-port 2 and BAUD 9600 and works OK
the
selection option for USB is blank
and
some more feedback...
In
June 2008 I emailed you requesting advice. I had a stock of ATMEL AT90S8535
microcontrollers and my copy of BASCOM-AVR 1.11.8.3, and I was after a
compatible USB programming setup. You sold me an Olimex-AVR-ISP500
and an Olimex-AVR-P40N-8535-8MHz. The ISP500 needed a copy of STK500.exe.
The first one I downloaded was a ver1.nn but I soon became aware that I
needed ver2.nn. I obtained a copy from the AVR website by downloading
AVRStudio. The setup works well with AT90S8535s & ATMEGA8536s,
but one needs to change $crystal = 8000000 to $crystal = 1000000
for the MEGA chip to function. I use a USB to RS232 adaptor to access
the COM functions of the P40N board. I hope the information is of
some use to somebody. Thank you for your assistance. regards, Bob
Foreman
Support:
If
you need additional support on the above product, and you can't find the
information you need in the documentation, then please contact support
at the address below:
Support
Forum:
http://www.sparkfun.com/cgi-bin/phpbb/index.php
This
product is from: OLIMEX Ltd
http://www.olimex.com
info
AT olimex.com
Mr.
Tsvetan Usunov
Back
To Top
