Prices
| Support
The
I/O 24 ULN2803 Switch Board is a very useful accessory board that allows
much higher voltage and current devices to be interfaced to the low level
logic provided by the I/O24 modules.
1 x
ULN2803 High Voltage / High Current Transistor Array
Indication
LED's for channel status
Screw
Terminal Blocks for outputs
Easy
connection by 10-way box header to suit standard IDC connector for connection
to the I/O port
72mm
Standard width for DIN Rail Modules
Dimensions
– 2.6 X 2.8 X 1 inches (65 X 72 X 25.4mm)
Click
Here for Datasheet
Customers
Subject:
Add USB to your product in 10 minutes.
From:
Bob Blick (bob at TED.NET)
Date:
Wed Nov 21 2001 - 15:20:40 PST
Reply-To:
pic microcontroller discussion list ?PICLIST@MITVMA.MIT.EDU>
On
Wed, 21 Nov 2001, John Hansen wrote:
>
So suppose you were going to design a device that would hook to a PC USB
>
port using this product. Wouldn't a device driver for the USB device
be
>
required? Is that supplied with the unit?
The
chip it's based on is very very nice and support is also nice. Also it
has native support under Linux(kernel 2.4 and above). Appears as an RS232
port to the system. I've been using adapter cables using this chip and
it's my favorite(even MPLAB will run a Picstart+ off a USB port with it!).
Way
to go, Don! Cheers, Bob
Subject:
Add USB to your product in 10 minutes.
Date:
Thu, 22 Nov 2001 16:31:31 +0000
From:
kevin palmer ?kjp@SIGNAL.QINETIQ.COM>
Reply-To:
pic microcontroller discussion list ?PICLIST@MITVMA.MIT.EDU>
I haven't
use this board but I have used the chip, Its dead easy to use , the pc
just sees it as a serial port so you can access it with hyperterm or mscomm
in VB Kevin
Reviews
Check
out Craig Peacock's on-line
article at beyondlogic.org entitled "USB with the simplicity of RS-232
-High Speed USB Controllers for Serial and FIFO Applications" which contains
a well written overview of our FT8U232AM and FT8U245AM devices.
Also
have a look at Jan Axelson's USB page at:
http://www.lvr.com/usb.htm
Support:
If
you need additional support on the above product, and you can't find the
information you need in the documentation, then please contact support
at the address below:
These
products are from: Elexol Pty Ltd
http://www.elexol.com
Paul
Lundh
paull
at elexol.com
The
company is located at Bundall on Australia’s Gold Coast in the State of
Queensland.
Business
Address
Suite
11, Level 2, Commerce Centre
146
Bundall Road
Bundall,
Queensland 4217
Australia
Postal
Address
PO
BOX 5972 GCMC
Bundall
, QLD 4217
Australia
Phone:
+617 5574 3988
Fax:
+617 5574 3833
Back
To Top
